 |
|
With OtsTurntables's low latency audio pipeline you are able to configure a separate output channel for cue. This feature is great for DJs who wish to listen and prepare the next song before it goes to air.
To find the "CUE" output device click on the Ots Labs Power Amplifier in the OtsTurntables window. This will open the Output Configuration dialog box. The cue channel feature is in the Primary audio output section.
There are three methods of obtaining cue channel output in OtsTurntables: right cue channel, rear cue channel, and second soundcard cue channel.
With this method you use the right channel of your soundcard for the cue channel (same soundcard you are using for your main "ON-AIR" output). The on-air signal is mixed to mono and then fed through the left channel of your standard soundcard. The cue channel is also converted to mono, but fed through the right channel.
Note: When using this method the Save as Wave functionality still receives a full stereo signal.
For instructions on configuring the right channel for cue click here.
Rear cue channel
With this method the rear channels of the main soundcard are used for cue. For this method to work correctly the main soundcard must be a 3D card; it must have at least 4 channels of output; must be set up to use all channels (set the speaker setup properties to "quadraphonic"); and must be capable of mixing 3D buffers in hardware. This is the preferred method for most people, and results in a full-stereo low-latency cue channel.
For instructions on configuring the rear channels for cue click here.
Second soundcard cue channel
To use this method, you must have a second stereo soundcard in your system. Although this method appears to be ideal, it is not. You may notice very occasional dropped or repeated frames when using this method. These glitches will only be heard through the cue channel output, not the main on-air output, so you may not mind. (The cause of these glitches is due to the timing crystals in both of your soundcards not being exactly the same).
For instructions on configuring a second soundcard for cue click here.
Tip: If you have received the "Failed to allocate audio device. Close other audio programs and start again" error message, this could be because you are trying to enable the same soundcard in the both the "ON-AIR" and "CUE" output channels. You can not allocate the same device in both places.
Tip: If you are trying to connect headphones directly into your soundcard output channels you will find there is not enough level to drive your headphones. You will need to amplify this signal up to headphone level. You can purchase small amplification units for this purpose from an electronics store.
How to remove "ON-AIR" signal from the cue channel
How to optimize Air & Cue cross talk
How to set up your soundcard (main channel)
How to calibrate your soundcard